Synthesis of the D-Galactopyranoside Derivative of C_(60)

ThefascinatingsbocturesandpropertiesoffullereneshaveoPeneduPanewfieldofchendstry.Inparticular,F.Wudletal.l'2haveshownthatwatersofubleC6ocomPoundsinhibittheHITVen-zymesprotease(HIVP)andreversetranscriPtase(HIVRT).IthasbeenafocusofstUdytoinvestigatethebiologicalactivitiesofthesenovelsubstances.Fortheirpossiblemedicaluses,tolinkC6omoleculetonaturalProductssuchassugars,pephdes,amioacides,andsoonisanimPortantmethodinthisfield.Vasella3reportedthefirstglucosidederivativeofC6o'InthispaPer,w…     

颗粒速度在颗粒流稀疏流-密集流转变中的作用

用实验和计算模拟的方法研究了颗粒流中的颗粒速度与颗粒流特性的关系.实验研究发现当入口流量固定时，在出口上方高速运动的颗粒会使颗粒流由稀疏流向密集流转变的临界出口尺寸变小.当颗粒流转变为密集流后，颗粒速度的作用被出口上方的颗粒堆积区所消耗，最终变得与颗粒速度无关.二维分子动力学模拟计算得到了与实验相同的结论.通过二维分子动力学模拟计算，还给出了不同颗粒速度下体系的密度和速率在空间的分布图.这些分布图显示随着颗粒到达出口上方的瞬间速度的不同，颗粒堆积区的密度和高度均会改变，并最终导致颗粒流流动状态的改变. 关键词： 颗粒流 颗粒气体 分子动力学模拟     

紫外光激发下氧化锌纳米线的发光特性研究

室温条件下，用355 nm的激光激发氧化锌纳米线，测量了其发光光谱.观察到半宽度较小、峰值波长约382 nm的紫光峰和半宽度较宽、峰值波长约507 nm的绿光峰；两峰的发光强度随激发光功率密度的变化而变化，且均存在饱和效应，但各自的变化规律及饱和值的大小不同；紫光峰的中心波长随激发光功率密度的增加而发生了明显的红移.对两峰产生的机理、强度饱和值存在的原由、强度随激发光功率密度变化及紫光峰红移的起因进行了分析.     

Polymerization of cyclopentadiene initiated by methylaluminoxane

The polymerization of cyclopentadiene (CPD) was effectively initiated by methylaluminoxane (MAO) to generate poly(cyclopentadiene) (polyCPD). The effects on the polymerization of some reaction parameters such as the monomer concentration, the initiator concentration, and solvents were investigated. The conversion of CPD was monitored with gas chromatography to investigate the reaction kinetics. The polymerization rate was proportional to the concentrations of MAO in the first order and of the CPD monomer in the second order, and a reasonable cationic polymerization mechanism was suggested on the basis of the kinetic study. PolyCPD obtained at a low temperature could be dissolved in toluene or chloroform, and this indicated lower cross‐coupling during the polymerization reaction. ¹H NMR and IR analysis of the polymer indicated that there were almost equal amounts of 1,2‐enchainment and 1,4‐enchainment in the polymer chain. The measurement of polyCPD showed its unique properties as a potential candidate for stable wrappings or electronic packaging materials. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 264–272, 2006     

A copper‐based reverse atom‐transfer radical polymerization process for the living radical polymerization of polyacrylonitrile

The reverse atom‐transfer radical polymerization (RATRP) technique using CuCl₂/2,2′‐bipyridine (bipy) complex as a catalyst was applied to the living radical polymerization of acrylonitrile (AN). A hexasubstituted ethane thermal iniferter, diethyl 2,3‐dicyano‐2,3‐diphenylsuccinate (DCDPS), was firstly used as the initiator in this copper‐based RATRP initiation system. A CuCl₂ to bipy ratio of 0.5 not only gives the best control of molecular weight and its distribution, but also provides rather rapid reaction rate. The rate of polymerization increases with increasing the polymerization temperature, and the apparent activation energy was calculated to be 57.4 kJ mol^?1. Because the polymers obtained were end‐functionalized by chlorine atoms, they were used as macroinitiators to proceed the chain extension polymerization in the presence of CuCl/bipy catalyst system via a conventional ATRP process. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 226–231, 2006     

Synthesis of polyacrylonitrile via reverse atom transfer radical polymerization catalyzed by FeCl3/isophthalic acid

FeCl₃ coordinated by isophthalic acid was first used as a catalyst in the azobisisobutyronitrile‐initiated reverse atom transfer radical polymerization of acrylonitrile. N,N‐Dimethylformamide was used as a solvent to improve the solubility of the ligand. An FeCl₃‐to‐isophthalic acid ratio of 0.5 not only gave the best control of the molecular weight and its distribution but also provided rather a rapid reaction rate. The effects of different solvents on the polymerization of acrylonitrile were also investigated. The rate of the polymerization in N,N‐dimethylformamide was faster than that in propylene carbonate and toluene. The molecular weight of polyacrylonitrile agreed reasonably well with the theoretical molecular weight in N,N‐dimethylformamide. The rate of polymerization increased with increasing polymerization temperature, and the apparent activation energy was calculated to be 59.9 kJ mol^?1. Reverse atom transfer radical polymerization was first used to successfully synthesize acrylonitrile polymers with a molecular weight higher than 80,000 and a narrow polydispersity as low as 1.22. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 219–225, 2006     

Enhanced transmission of electromagnetic waves through metamaterials

This paper reviews our recent experimental and simulation results regarding the electromagnetic wave transmission through three configurations of sandwiching structures of metamaterials: a metallic mesh sandwiched between two identical layers composed of split rings, metallic fractals, and fractal slits, respectively. We observed the enhanced transmission of the waves through these three types of sandwiching composites with respect to the opaque metallic mesh. The locations of the transmission peaks in the spectrum are associated closely with the band characteristics of the sandwiching layer by appearing either on the left- or the right-hand side of its band. PACS 41.20.Jb; 42.70.Qs; 78.20.-e; 42.25.Bs; 47.53.+n     

准直小孔法自动调焦在激光直写入系统中的应用

本文介绍了一种新的自动调焦方法准直小孔法.对自动调焦的原理和后继电路处理方法作了详细的分析.它具有响应时间短、灵敏度高,能够很好的在激光直接写入系统中克服物镜工作台运动中导轨的不平和轴向窜动所造成的离焦。     

Amperometric flow-injection analysis of hydrazine by electrocatalytic oxidation at cobalt tetraphenylporphyrin modified electrode with heat treatment

Chemically modified electrodes prepared by treating the cobalt tetraphenylporphyrin modified glassy-carbon electrode at 750 degrees (HCME) are shown to catalyze the electrooxidation of hydrazine. The oxidation occurred at +0.63 V vs. Ag/AgCl (saturated potassium chloride) in pH 2.5 media. The catalytic response is evaluated with respect to solution pH, potential scan-rate, concentration dependence and flow-rate. The catalytic stability of the HCME is compared with that of the cobalt tetraphenylporphyrin adsorbed glassy-carbon electrode. The stability of the HCME was excellent in acidic solution and even in solutions containing organic solvent (50% CH(3)OH). When used as the sensing electrode in amperometric detection in flow-injection analysis, the HCME permitted sensitive detection of hydrazine at 0.5 V. The limit of detection was 0.1 ng. The linear range was from 50 ng to 2.4 mug. The method is very sensitive and selective.     

毛细管电泳紫外检测法测定莲须中的槲皮素、木犀草素、山萘酚、异槲皮甙

采用毛细管区带电泳紫外检测法(CZE-UV)同时测定中药莲须中槲皮素、木犀草素、山萘酚、异槲皮甙4种有效成分.研究了缓冲溶液的离子浓度、pH值和电压对分离度和迁移时间的影响,得到了最佳分离实验条件.在离子浓度为40 mmol/L Na2B4O7缓冲溶液(pH 9.0)中,分离电压为16 kV,波长为254 nm时,槲皮素、木犀草素、山萘酚、异槲皮甙4种物质在10 min内得到了良好的分离测定,其检出限分别为5.0、6.7、4.5和6.0 mg/L.本方法应用于实际样品的测定,结果令人满意.